• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Heat Transfer Enhancement From a Blade Tip-Cap Using Metal Foams

    Thumbnail
    View/Open
    JHTRAO-926057#114505_1.pdf (787.2Kb)
    Date
    2012
    Author
    Owen Sengstock
    Kamel Hooman
    Metadata
    Show full item record
    Abstract
    3D numerical results are presented to compare the heat transfer augmentation from a plate by using pin fins and metal foams. It is observed that maximizing the inlet velocity and pores per inch maximizes the overall heat transfer rate. The thickness of the foam layer has minimal effect on overall rates of heat transfer, but great effect on the maximum plate temperature. It has been shown that an optimum thickness exists which minimizes the hot spot temperature. Hot spots are generally located in the corners where velocities are the lowest. While the pressure drop remains almost unaltered, the heat transfer increases by 146% and 12% compared with a smooth channel and the optimal pin-fin data available in the literature, respectively. Interestingly, the additional mass of the foams, to achieve this performance, is approximately one-quarter of the best pin-fin sink quoted above.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/149327
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV