Show simple item record

dc.contributor.authorHailin Li
dc.contributor.authorW. Stuart Neill
dc.contributor.authorWallace L. Chippior
dc.date.accessioned2017-05-09T00:49:39Z
dc.date.available2017-05-09T00:49:39Z
dc.date.copyrightJune, 2012
dc.date.issued2012
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26583#022204_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/148653
dc.description.abstractThe combustion stability of a single-cylinder homogeneous charge compression ignition (HCCI) engine operated with n-heptane was experimentally investigated over a range of engine speeds (N), intake temperatures and pressures, compression ratios (CR), air/fuel ratios (AFR), and exhaust gas recirculation (EGR) rates. These parameters were varied to alter the combustion phasing from an overly advanced condition where engine knock occurred to an overly retarded condition where incomplete combustion was observed with excessive emissions of carbon monoxide (CO) and unburned hydrocarbons (UHC). The combustion stability was quantified by the coefficients of variation in indicated mean effective pressure (COVimep ) and peak cylinder pressure (COVPmax ). Cycle-to-cycle variations in the HCCI combustion behavior of this engine were shown to depend strongly on the combustion phasing, defined in this study as the crank angle position where 50% of the energy was released (CA50). In general, combustion instability increased significantly when the combustion phasing was overly retarded. The combustion phasing was limited to conditions where the COVimep was 5% or less as engine operation became difficult to control beyond this point. Based on the experimental data, the combustion phasing limit was approximately a linear function of the amount of fuel inducted in each cycle. Stable HCCI combustion could be obtained with progressively retarded combustion phasing as the fuel flow rate increased. In comparison, stable HCCI combustion was only obtained under very advanced combustion phasing for low load operating conditions. Investigation of the experimental data reveals that the cyclic variations in HCCI combustion were due to cycle-to-cycle variations in total heat release (THR). The combustion completeness of the previous cycle affected the in-cylinder bulk mixture conditions and resultant heat release process of the following engine cycle.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Investigation of HCCI Combustion Stability Using n-Heptane
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.4005700
dc.journal.fristpage22204
dc.identifier.eissn1528-8994
dc.keywordsCombustion
dc.keywordsFuels
dc.keywordsEngines
dc.keywordsStability
dc.keywordsHomogeneous charge compression ignition engines
dc.keywordsExhaust gas recirculation
dc.keywordsPressure
dc.keywordsCylinders
dc.keywordsCompression
dc.keywordsCycles
dc.keywordsHeptane
dc.keywordsTemperature AND Mixtures
dc.treeJournal of Energy Resources Technology:;2012:;volume( 134 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record