• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    An Experimental Investigation of HCCI Combustion Stability Using n-Heptane

    Thumbnail
    View/Open
    JERTD2-26583#022204_1.pdf (854.2Kb)
    Date
    2012
    Author
    Hailin Li
    W. Stuart Neill
    Wallace L. Chippior
    Metadata
    Show full item record
    Abstract
    The combustion stability of a single-cylinder homogeneous charge compression ignition (HCCI) engine operated with n-heptane was experimentally investigated over a range of engine speeds (N), intake temperatures and pressures, compression ratios (CR), air/fuel ratios (AFR), and exhaust gas recirculation (EGR) rates. These parameters were varied to alter the combustion phasing from an overly advanced condition where engine knock occurred to an overly retarded condition where incomplete combustion was observed with excessive emissions of carbon monoxide (CO) and unburned hydrocarbons (UHC). The combustion stability was quantified by the coefficients of variation in indicated mean effective pressure (COVimep ) and peak cylinder pressure (COVPmax ). Cycle-to-cycle variations in the HCCI combustion behavior of this engine were shown to depend strongly on the combustion phasing, defined in this study as the crank angle position where 50% of the energy was released (CA50). In general, combustion instability increased significantly when the combustion phasing was overly retarded. The combustion phasing was limited to conditions where the COVimep was 5% or less as engine operation became difficult to control beyond this point. Based on the experimental data, the combustion phasing limit was approximately a linear function of the amount of fuel inducted in each cycle. Stable HCCI combustion could be obtained with progressively retarded combustion phasing as the fuel flow rate increased. In comparison, stable HCCI combustion was only obtained under very advanced combustion phasing for low load operating conditions. Investigation of the experimental data reveals that the cyclic variations in HCCI combustion were due to cycle-to-cycle variations in total heat release (THR). The combustion completeness of the previous cycle affected the in-cylinder bulk mixture conditions and resultant heat release process of the following engine cycle.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/148653
    Collections
    • Journal of Energy Resources Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV