Show simple item record

dc.contributor.authorNikhil Ravi
dc.contributor.authorChen-Fang Chang
dc.contributor.authorHan Ho Song
dc.contributor.authorJ. Christian Gerdes
dc.contributor.authorHsien-Hsin Liao
dc.contributor.authorAdam F. Jungkunz
dc.date.accessioned2017-05-09T00:49:19Z
dc.date.available2017-05-09T00:49:19Z
dc.date.copyrightJanuary, 2012
dc.date.issued2012
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-25516#011016_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/148546
dc.description.abstractHomogeneous charge compression ignition (HCCI) is currently being pursued as a cleaner and more efficient alternative to conventional engine strategies. Control of the load and phasing of combustion is critical in the effort to ensure reliable operation of an HCCI engine over a wide operating range. This paper presents an approach for modeling the effect of a small pilot injection during the recompression process of an HCCI engine, and a controller that uses the timing of this pilot injection to control the phasing of combustion. The model is a nonlinear physical model that captures the effect of fuel quantity and intake and exhaust valve timings on work output and combustion phasing. It is seen that around the operating points considered, the effect of a pilot injection can be modeled as a change in the Arrhenius threshold, an analytical construct used to model the phasing of combustion as a function of the thermodynamic state of the reactant mixture. The relationship between injection timing and combustion phasing can be separated into a linear, analytical component and a nonlinear, empirical component. Two different control strategies based on this model are presented, both of which enabled steady operation at low load conditions and effectively track desired load-phasing trajectories. These strategies demonstrate the potential of split injection as a practical cycle-by-cycle control knob requiring only minimal valve motion that would be easily achievable on current production engines equipped with cam phasers.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleModeling and Control of an Exhaust Recompression HCCI Engine Using Split Injection
dc.typeJournal Paper
dc.journal.volume134
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.4004787
dc.journal.fristpage11016
dc.identifier.eissn1528-9028
dc.keywordsCombustion
dc.keywordsControl equipment
dc.keywordsFuels
dc.keywordsEngines
dc.keywordsCycles
dc.keywordsHomogeneous charge compression ignition engines
dc.keywordsExhaust systems
dc.keywordsCylinders AND Valves
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2012:;volume( 134 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record