• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Modeling and Control of an Exhaust Recompression HCCI Engine Using Split Injection

    Thumbnail
    View/Open
    JDSMAA-25516#011016_1.pdf (2.339Mb)
    Date
    2012
    Author
    Nikhil Ravi
    Chen-Fang Chang
    Han Ho Song
    J. Christian Gerdes
    Hsien-Hsin Liao
    Adam F. Jungkunz
    Metadata
    Show full item record
    Abstract
    Homogeneous charge compression ignition (HCCI) is currently being pursued as a cleaner and more efficient alternative to conventional engine strategies. Control of the load and phasing of combustion is critical in the effort to ensure reliable operation of an HCCI engine over a wide operating range. This paper presents an approach for modeling the effect of a small pilot injection during the recompression process of an HCCI engine, and a controller that uses the timing of this pilot injection to control the phasing of combustion. The model is a nonlinear physical model that captures the effect of fuel quantity and intake and exhaust valve timings on work output and combustion phasing. It is seen that around the operating points considered, the effect of a pilot injection can be modeled as a change in the Arrhenius threshold, an analytical construct used to model the phasing of combustion as a function of the thermodynamic state of the reactant mixture. The relationship between injection timing and combustion phasing can be separated into a linear, analytical component and a nonlinear, empirical component. Two different control strategies based on this model are presented, both of which enabled steady operation at low load conditions and effectively track desired load-phasing trajectories. These strategies demonstrate the potential of split injection as a practical cycle-by-cycle control knob requiring only minimal valve motion that would be easily achievable on current production engines equipped with cam phasers.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/148546
    Collections
    • Journal of Dynamic Systems, Measurement, and Control

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV