Show simple item record

dc.contributor.authorFlorian Hoefler
dc.contributor.authorNils Dietrich
dc.contributor.authorJens Wolfersdorf
dc.date.accessioned2017-05-09T00:44:54Z
dc.date.available2017-05-09T00:44:54Z
dc.date.copyrightSeptember, 2011
dc.date.issued2011
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27922#091601_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/146603
dc.description.abstractA confined jet impingement configuration has been investigated in which the matter of interest is the convective heat transfer from the air flow to the passage walls. The geometry is similar to gas turbine blade cooling applications. The setup is distinct from usual cooling passages by the fact that no crossflow and no bulk flow directions are present. The flow exhausts through two staggered rows of holes opposing the impingement wall. Hence, a complex 3-D vortex system arises, which entails a complex heat transfer situation. The transient thermochromic liquid crystal (TLC) method was used in previous studies to measure the heat transfer on the passage walls. Due to the nature of these experiments, the fluid as well as the wall temperature vary with location and time. As a prerequisite of the transient TLC technique, the heat transfer coefficient is assumed to be constant over the transient experiment. Therefore, it is the scope of this article to qualify this assumption and to validate the results at discrete locations. For this purpose, fast response surface thermocouples and heat flux sensors were applied, in order to gain information on the temporal evolution of the wall heat fluxes. The linear relation between heat flux and temperature difference could be verified for all measurement sites. This validates the assumption of a constant heat transfer coefficient. Nusselt number evaluations from independent techniques show a good agreement, considering the respective uncertainty ranges. For all investigated sites, the Nusselt numbers range within ±9% of the values gained from the TLC measurement.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleHeat Transfer Experiments in a Confined Jet Impingement Configuration Using Transient Techniques
dc.typeJournal Paper
dc.journal.volume133
dc.journal.issue9
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4003827
dc.journal.fristpage91601
dc.identifier.eissn1528-8943
dc.keywordsFluids
dc.keywordsMeasurement
dc.keywordsWall temperature
dc.keywordsHeat flux
dc.keywordsHeat transfer coefficients
dc.keywordsTemperature
dc.keywordsHeat transfer
dc.keywordsSensors
dc.keywordsThermocouples
dc.keywordsCooling
dc.keywordsUncertainty AND Geometry
dc.treeJournal of Heat Transfer:;2011:;volume( 133 ):;issue: 009
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record