Show simple item record

dc.contributor.authorAmanie N. Abdelmessih
dc.contributor.authorThomas J. Horn
dc.date.accessioned2017-05-09T00:39:06Z
dc.date.available2017-05-09T00:39:06Z
dc.date.copyrightFebruary, 2010
dc.date.issued2010
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27880#023304_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/143921
dc.description.abstractHigh heat fluxes are encountered in numerous applications, such as on the surfaces of hypersonic vehicles in flight, in fires, and within engines. The calibration of heat flux gauges may be performed in a dual cavity cylindrical blackbody. Insertion of instruments into the cavity disturbs the thermal equilibrium resulting in a transient calibration environment. To characterize the transient heat fluxes, experiments were performed on a dual cavity cylindrical blackbody at nominal temperatures varying from 800°C to 1900°C in increments of 100°C. The pre-insertion, steady state, axial temperature profile is compared experimentally and numerically. Detailed transient thermal models have been developed to simulate the heat flux calibration process at two extreme fluxes: the high flux is 1 MW/m2 and the relatively low is 70 kW/m2. Based on experiments and numerical analysis, the optimum heat flux sensor insertion location as measured from the center partition was determined. The effect of convection (natural and forced) in the blackbody cavity during the insertion is calculated and found to be less than 2% at high temperatures but reaches much higher values at relatively lower temperatures. The transient models show the effect of inserting a heat flux gauge at room temperature on the thermal equilibrium of the blackbody at 1800°C and 800°C nominal temperatures. Also, heat flux sensor outputs are derived from computed sensor temperature distributions and compared with experimental results. The numerical heat flux agreed with the experimental results to within 5%, which indicates that the numerical models captured the transient thermal physics during the calibration. Based on numerical models and all experimental runs the heat transfer mechanisms are explained.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental and Computational Characterization of High Heat Fluxes During Transient Blackbody Calibrations
dc.typeJournal Paper
dc.journal.volume132
dc.journal.issue2
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.4000187
dc.journal.fristpage23304
dc.identifier.eissn1528-8943
dc.keywordsTemperature
dc.keywordsGages
dc.keywordsCavities
dc.keywordsHeat flux
dc.keywordsInterior walls
dc.keywordsCalibration
dc.keywordsHeat AND Flux (Metallurgy)
dc.treeJournal of Heat Transfer:;2010:;volume( 132 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record