• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Experimental and Computational Characterization of High Heat Fluxes During Transient Blackbody Calibrations

    Thumbnail
    View/Open
    JHTRAO-27880#023304_1.pdf (1.475Mb)
    Date
    2010
    Author
    Amanie N. Abdelmessih
    Thomas J. Horn
    Metadata
    Show full item record
    Abstract
    High heat fluxes are encountered in numerous applications, such as on the surfaces of hypersonic vehicles in flight, in fires, and within engines. The calibration of heat flux gauges may be performed in a dual cavity cylindrical blackbody. Insertion of instruments into the cavity disturbs the thermal equilibrium resulting in a transient calibration environment. To characterize the transient heat fluxes, experiments were performed on a dual cavity cylindrical blackbody at nominal temperatures varying from 800°C to 1900°C in increments of 100°C. The pre-insertion, steady state, axial temperature profile is compared experimentally and numerically. Detailed transient thermal models have been developed to simulate the heat flux calibration process at two extreme fluxes: the high flux is 1 MW/m2 and the relatively low is 70 kW/m2. Based on experiments and numerical analysis, the optimum heat flux sensor insertion location as measured from the center partition was determined. The effect of convection (natural and forced) in the blackbody cavity during the insertion is calculated and found to be less than 2% at high temperatures but reaches much higher values at relatively lower temperatures. The transient models show the effect of inserting a heat flux gauge at room temperature on the thermal equilibrium of the blackbody at 1800°C and 800°C nominal temperatures. Also, heat flux sensor outputs are derived from computed sensor temperature distributions and compared with experimental results. The numerical heat flux agreed with the experimental results to within 5%, which indicates that the numerical models captured the transient thermal physics during the calibration. Based on numerical models and all experimental runs the heat transfer mechanisms are explained.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/143921
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV