Show simple item record

dc.contributor.authorBasar Ozkan
dc.contributor.authorMarco Pengov
dc.contributor.authorDonald Margolis
dc.date.accessioned2017-05-09T00:27:20Z
dc.date.available2017-05-09T00:27:20Z
dc.date.copyrightNovember, 2008
dc.date.issued2008
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26473#061002_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/137637
dc.description.abstractA controller output observer is used for estimating specific outputs from a physical system through the use of alternative outputs that are measured. In most cases these estimated signals can be measured directly using sensors. However, some outputs are either not possible to measure directly or alternative outputs are just easier to measure. This paper focused on a method to estimate immeasurable quantities, in near real time, through the use of physical models and measured quantities. This can be done through the use of classical observers as introduced by in 1964 (“ Observing the state of a Linear System,” IEEE Trans. Mil. Electron., 8, pp. 74–80) However, since observers estimate the system states, one would have to again estimate the sought after outputs by another method, such as a constitutive relationship. The method proposed here shows that certain signals can be estimated directly by using a controller but without using a constitutive law. These estimated quantities are inputs to a model of the real system. In other words, these inputs drive the observer model. A promising use for the controller output observer is estimation of tire forces in vehicles. This is because tires are very difficult to model accurately, and even if the tire is modeled accurately, the surface conditions of the road must be known to predict tire forces. The controller output observer does not require a model of the tires. The method is tested using a vehicle model. Real measurements from a vehicle are used to show that the method succeeds in estimating quantities from the real vehicle.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Controller Output Observer: Estimation of Vehicle Tire Cornering and Normal Forces
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue6
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2957627
dc.journal.fristpage61002
dc.identifier.eissn1528-9028
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2008:;volume( 130 ):;issue: 006
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record