• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Dynamic Systems, Measurement, and Control
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    The Controller Output Observer: Estimation of Vehicle Tire Cornering and Normal Forces

    Thumbnail
    View/Open
    JDSMAA-26473#061002_1.pdf (1.347Mb)
    Date
    2008
    Author
    Basar Ozkan
    Marco Pengov
    Donald Margolis
    Metadata
    Show full item record
    Abstract
    A controller output observer is used for estimating specific outputs from a physical system through the use of alternative outputs that are measured. In most cases these estimated signals can be measured directly using sensors. However, some outputs are either not possible to measure directly or alternative outputs are just easier to measure. This paper focused on a method to estimate immeasurable quantities, in near real time, through the use of physical models and measured quantities. This can be done through the use of classical observers as introduced by in 1964 (“ Observing the state of a Linear System,” IEEE Trans. Mil. Electron., 8, pp. 74–80) However, since observers estimate the system states, one would have to again estimate the sought after outputs by another method, such as a constitutive relationship. The method proposed here shows that certain signals can be estimated directly by using a controller but without using a constitutive law. These estimated quantities are inputs to a model of the real system. In other words, these inputs drive the observer model. A promising use for the controller output observer is estimation of tire forces in vehicles. This is because tires are very difficult to model accurately, and even if the tire is modeled accurately, the surface conditions of the road must be known to predict tire forces. The controller output observer does not require a model of the tires. The method is tested using a vehicle model. Real measurements from a vehicle are used to show that the method succeeds in estimating quantities from the real vehicle.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/137637
    Collections
    • Journal of Dynamic Systems, Measurement, and Control

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV