Show simple item record

dc.contributor.authorS. W. Lee
dc.contributor.authorH. S. Ahn
dc.contributor.authorS. C. Lau
dc.date.accessioned2017-05-09T00:24:31Z
dc.date.available2017-05-09T00:24:31Z
dc.date.copyrightNovember, 2007
dc.date.issued2007
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27826#1529_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136176
dc.description.abstractThe heat transfer characteristics of airflows in serpentine cooling channels in stator vanes of gas turbines were studied. The cooling channels were modeled as a two-pass trapezoidal channel with a 180deg turn. Naphthalene sublimation experiments were conducted and the heat and mass transfer analogy was applied to study the local heat (mass) transfer distributions on one of the two primary walls of the channel. Results were obtained for turbulent airflow through the channel with smooth walls, and with transverse ribs on one wall and on two opposite walls, over a range of Reynolds numbers between about 10,000 and 60,000. The results showed that there was a very large variation of the local heat (mass) transfer distribution in the turn and downstream of the turn. In all of the cases studied, the regional average heat (mass) transfer was higher on the downstream half of the turn than on the upstream half of the turn and was higher in the turn with the flow entering the channel through the smaller straight section than when the flow was reversed. The shape of the local heat (mass) transfer distribution at the turn was not significantly affected by varying the air mass flow rate. In the smooth wall case, the local heat (mass) transfer was high near the end wall and the downstream outer wall in the turn and was relatively low in two regions near the upstream outer wall and the downstream edge at the tip of the divider wall in the turn. With ribs on two opposite walls, the variation of the local heat (mass) transfer was larger, especially in the turn and downstream of the turn, than in the smooth wall case. The pressure drop across the turn was higher in the case of the flow entering the channel through the larger straight section than when the flow was reversed. As expected, the ribs increased the pressure drop across the turn.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleHeat (Mass) Transfer Distribution in a Two-Pass Trapezoidal Channel With a 180deg Turn
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue11
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2764084
dc.journal.fristpage1529
dc.journal.lastpage1537
dc.identifier.eissn1528-8943
dc.keywordsMass transfer
dc.keywordsChannels (Hydraulic engineering) AND Flow (Dynamics)
dc.treeJournal of Heat Transfer:;2007:;volume( 129 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record