• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Heat Transfer
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Heat (Mass) Transfer Distribution in a Two-Pass Trapezoidal Channel With a 180deg Turn

    Thumbnail
    View/Open
    JHTRAO-27826#1529_1.pdf (1.077Mb)
    Date
    2007
    Author
    S. W. Lee
    H. S. Ahn
    S. C. Lau
    Metadata
    Show full item record
    Abstract
    The heat transfer characteristics of airflows in serpentine cooling channels in stator vanes of gas turbines were studied. The cooling channels were modeled as a two-pass trapezoidal channel with a 180deg turn. Naphthalene sublimation experiments were conducted and the heat and mass transfer analogy was applied to study the local heat (mass) transfer distributions on one of the two primary walls of the channel. Results were obtained for turbulent airflow through the channel with smooth walls, and with transverse ribs on one wall and on two opposite walls, over a range of Reynolds numbers between about 10,000 and 60,000. The results showed that there was a very large variation of the local heat (mass) transfer distribution in the turn and downstream of the turn. In all of the cases studied, the regional average heat (mass) transfer was higher on the downstream half of the turn than on the upstream half of the turn and was higher in the turn with the flow entering the channel through the smaller straight section than when the flow was reversed. The shape of the local heat (mass) transfer distribution at the turn was not significantly affected by varying the air mass flow rate. In the smooth wall case, the local heat (mass) transfer was high near the end wall and the downstream outer wall in the turn and was relatively low in two regions near the upstream outer wall and the downstream edge at the tip of the divider wall in the turn. With ribs on two opposite walls, the variation of the local heat (mass) transfer was larger, especially in the turn and downstream of the turn, than in the smooth wall case. The pressure drop across the turn was higher in the case of the flow entering the channel through the larger straight section than when the flow was reversed. As expected, the ribs increased the pressure drop across the turn.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/136176
    Collections
    • Journal of Heat Transfer

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV