Show simple item record

dc.contributor.authorTony D. Andrews
dc.contributor.authorFred E. Brine
dc.date.accessioned2017-05-09T00:21:23Z
dc.date.available2017-05-09T00:21:23Z
dc.date.copyrightMay, 2006
dc.date.issued2006
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28467#162_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/134520
dc.description.abstractThis paper describes a range of hydraulic fatigue and pressure tests carried out on gun barrels and ordnance components in support of weapons research and development programs. Cyclic testing of representative sections of large caliber guns has been routinely carried out to determine safe fatigue life for operational use. Ultrasonic techniques have been developed for mapping multiple cracks within the gun barrels by which periodic examinations of barrels during testing have been used to build up histories of crack initiation and growth. In relatively unworn barrels multiple cracks, initiated along each rifling groove, are shown to form in an extremely stable array that can grow to several millimeters depth, in agreement with calculated stress intensity factors, before one crack accelerates to dominate final failure. The development of localized erosion from extensive firing is shown to significantly affect the subsequent hydraulic fatigue cycling by generation of only one or two cracks as well as the prior removal of heavily prestressed bore material. Tests on fume extractor sections of barrels show that cracking initiates in the jet holes and only grows to the bore at late stages. Introduction of different levels of autofrettage acts to bias the radial location of the cracks. An extensive experimental program of work has been carried out in support of design studies on mid-wall cooled gun barrels exploring a number of different configurations for construction of compound tubes and the results of numerical simulations of the assembly process have been compared with strain gauge measurements during the experimental procedure on scale tubes. Subsequent hydraulic cycling was used to determine the fatigue implications of the processing route.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleHydraulic Testing of Ordnance Components
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2179433
dc.journal.fristpage162
dc.journal.lastpage167
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsStress
dc.keywordsFracture (Materials)
dc.keywordsFracture (Process)
dc.keywordsTesting
dc.keywordsFailure
dc.keywordsFiring (materials)
dc.keywordsWeapons
dc.keywordsGun barrels
dc.keywordsFatigue
dc.keywordsErosion
dc.keywordsFatigue life
dc.keywordsAutofrettage
dc.keywordsManufacturing
dc.keywordsGuns AND Computer simulation
dc.treeJournal of Pressure Vessel Technology:;2006:;volume( 128 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record