Show simple item record

dc.contributor.authorJong-Ning Aoh
dc.contributor.authorChung-Sheng Wei
dc.contributor.authorPh. D. Candidate
dc.date.accessioned2017-05-09T00:10:22Z
dc.date.available2017-05-09T00:10:22Z
dc.date.copyrightApril, 2003
dc.date.issued2003
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27045#107_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/128490
dc.description.abstractExperimental validation of the calibration coefficients for integral hole-drilling method obtained from an improved three-dimensional FEM model was achieved using bending test of a cantilever beam. The experimental setup is a simple yet accurate method to validate the calibration coefficients obtained by a three-dimensional FEM model. With this experiment, we also validate the adequacy of the criterion applied for thin or thick plates in a previous work. The relieved stresses calculated from the calibration coefficients of the three-dimensional FEM model were compared with those calculated from two-dimensional model calibration coefficients. The results show that the accuracy of relieved stress calculation has been greatly improved as the calibration coefficients based on a three-dimensional model are used for integral hole-drilling method. Significant error in the residual stress measurement and calculation could be arisen if calibration coefficients for integral hole-drilling method were not chosen correctly for corresponding thin plate or thick plate cases according the results of the bending test of cantilever beam. A transitional dimensionless thickness was proposed by examining the calculated relieved stresses obtained from the calibration coefficients for different plate thickness. The probability bounds of relieved stress corresponding to both cases were also calculated to further reveal the improvement of the calibration coefficients obtained from the three-dimensional model.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOn the Improvement of Calibration Coefficients for Hole-Drilling Integral Method: Part II—Experimental Validation of Calibration Coefficients
dc.typeJournal Paper
dc.journal.volume125
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1543972
dc.journal.fristpage107
dc.journal.lastpage115
dc.identifier.eissn1528-8889
dc.keywordsDrilling
dc.keywordsStress
dc.keywordsCalibration
dc.keywordsErrors
dc.keywordsThree-dimensional models
dc.keywordsThickness
dc.keywordsProbability
dc.keywordsStrain measurement AND Cantilever beams
dc.treeJournal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record