• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    On the Improvement of Calibration Coefficients for Hole-Drilling Integral Method: Part II—Experimental Validation of Calibration Coefficients

    Thumbnail
    View/Open
    JEMTA8-27045#107_1.pdf (325.8Kb)
    Date
    2003
    Author
    Jong-Ning Aoh
    Chung-Sheng Wei
    Ph. D. Candidate
    Metadata
    Show full item record
    Abstract
    Experimental validation of the calibration coefficients for integral hole-drilling method obtained from an improved three-dimensional FEM model was achieved using bending test of a cantilever beam. The experimental setup is a simple yet accurate method to validate the calibration coefficients obtained by a three-dimensional FEM model. With this experiment, we also validate the adequacy of the criterion applied for thin or thick plates in a previous work. The relieved stresses calculated from the calibration coefficients of the three-dimensional FEM model were compared with those calculated from two-dimensional model calibration coefficients. The results show that the accuracy of relieved stress calculation has been greatly improved as the calibration coefficients based on a three-dimensional model are used for integral hole-drilling method. Significant error in the residual stress measurement and calculation could be arisen if calibration coefficients for integral hole-drilling method were not chosen correctly for corresponding thin plate or thick plate cases according the results of the bending test of cantilever beam. A transitional dimensionless thickness was proposed by examining the calculated relieved stresses obtained from the calibration coefficients for different plate thickness. The probability bounds of relieved stress corresponding to both cases were also calculated to further reveal the improvement of the calibration coefficients obtained from the three-dimensional model.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/128490
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV