| dc.contributor.author | Stuart Barnes | |
| dc.contributor.author | Richard Morgan | |
| dc.contributor.author | Andrew Skeen | |
| dc.date.accessioned | 2017-05-09T00:10:20Z | |
| dc.date.available | 2017-05-09T00:10:20Z | |
| dc.date.copyright | October, 2003 | |
| dc.date.issued | 2003 | |
| dc.identifier.issn | 0094-4289 | |
| dc.identifier.other | JEMTA8-27052#378_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/128464 | |
| dc.description.abstract | Although the abrasive reinforcement in MMCs primarily controls their machining behavior, the properties of the matrix also exert an influence. A 1200 W diode laser was used, due to the large footprint (5×0.3 mm) and the short wavelength (0.94 μm) to pre-treat a 2618 (18% SiC) alloy. The laser heating and self-quenching of the material modified the matrix properties. Machining performance was then assessed by measuring tool wear and edge condition, cutting forces, surface finish, and sub-surface damage. Results indicated that pre-treatment gave less wear, lower forces, and less sub-surface damage although abrasion remained the primary wear mechanism. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Effect of Laser Pre-Treatment on the Machining Performance of Aluminum/SiC MMC | |
| dc.type | Journal Paper | |
| dc.journal.volume | 125 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Engineering Materials and Technology | |
| dc.identifier.doi | 10.1115/1.1605112 | |
| dc.journal.fristpage | 378 | |
| dc.journal.lastpage | 384 | |
| dc.identifier.eissn | 1528-8889 | |
| dc.keywords | Wear | |
| dc.keywords | Aluminum | |
| dc.keywords | Lasers | |
| dc.keywords | Machining AND Cutting | |
| dc.tree | Journal of Engineering Materials and Technology:;2003:;volume( 125 ):;issue: 004 | |
| dc.contenttype | Fulltext | |