• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Effect of Laser Pre-Treatment on the Machining Performance of Aluminum/SiC MMC

    Thumbnail
    View/Open
    JEMTA8-27052#378_1.pdf (615.5Kb)
    Date
    2003
    Author
    Stuart Barnes
    Richard Morgan
    Andrew Skeen
    Metadata
    Show full item record
    Abstract
    Although the abrasive reinforcement in MMCs primarily controls their machining behavior, the properties of the matrix also exert an influence. A 1200 W diode laser was used, due to the large footprint (5×0.3 mm) and the short wavelength (0.94 μm) to pre-treat a 2618 (18% SiC) alloy. The laser heating and self-quenching of the material modified the matrix properties. Machining performance was then assessed by measuring tool wear and edge condition, cutting forces, surface finish, and sub-surface damage. Results indicated that pre-treatment gave less wear, lower forces, and less sub-surface damage although abrasion remained the primary wear mechanism.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/128464
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV