Show simple item record

dc.contributor.authorM. Zehetbauer
dc.contributor.authorT. Ungár
dc.contributor.authorI. Kopacz
dc.contributor.authorS. Bernstorff
dc.contributor.authorE. Schafler
dc.date.accessioned2017-05-09T00:07:38Z
dc.date.available2017-05-09T00:07:38Z
dc.date.copyrightJanuary, 2002
dc.date.issued2002
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27029#41_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126890
dc.description.abstractDislocation densities, arrangements and long range internal stresses in cold rolled polycrystalline Cu, Ni, and Al, as well as in cold torsioned Fe, were determined by X-ray diffraction profile analysis using synchrotron radiation. At different deformation degrees, scanning measurements across single grains with a focal spot of less than 50 μm were carried out, in order to inform on the features of the deformation induced substructure. At small deformations including stage III, the dislocation densities and internal stresses are uniform within single grains while at higher deformations in stages IV and V, the dislocation densities and long range internal stresses exhibit opposite fluctuations. In stage IV these fluctuations correspond to the formation of polarized tilt walls (PTW’s) from polarized dipole walls (PDW’s). In contrast to the PDW’s, the PTW’s cause a much higher misorientation in between adjacent lattice areas. This transformation, which is the main element of the progressing fragmentation process during large strain deformation, occurs in all metals studied regardless of dislocation mobility and/or lattice type. Approaching higher strains in stage V, however, these parameters gain some importance especially when the deformation occurs in an iterative way. If the mobility is high, marked static recovery takes place between the single deformation passes, which results in decreases of both dislocation density and local internal stress, and no formation of PTW’s is observed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInvestigation of the Microstructural Evolution During Large Strain Cold Working of Metals by Means of Synchrotron Radiation—A Comparative Overview
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1421049
dc.journal.fristpage41
dc.journal.lastpage47
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsMetals
dc.keywordsStress
dc.keywordsSynchrotron radiation
dc.keywordsStructural mechanics
dc.keywordsDislocation density
dc.keywordsDislocations
dc.keywordsWork hardening AND Fluctuations (Physics)
dc.treeJournal of Engineering Materials and Technology:;2002:;volume( 124 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record