• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Investigation of the Microstructural Evolution During Large Strain Cold Working of Metals by Means of Synchrotron Radiation—A Comparative Overview

    Thumbnail
    View/Open
    JEMTA8-27029#41_1.pdf (151.7Kb)
    Date
    2002
    Author
    M. Zehetbauer
    T. Ungár
    I. Kopacz
    S. Bernstorff
    E. Schafler
    Metadata
    Show full item record
    Abstract
    Dislocation densities, arrangements and long range internal stresses in cold rolled polycrystalline Cu, Ni, and Al, as well as in cold torsioned Fe, were determined by X-ray diffraction profile analysis using synchrotron radiation. At different deformation degrees, scanning measurements across single grains with a focal spot of less than 50 μm were carried out, in order to inform on the features of the deformation induced substructure. At small deformations including stage III, the dislocation densities and internal stresses are uniform within single grains while at higher deformations in stages IV and V, the dislocation densities and long range internal stresses exhibit opposite fluctuations. In stage IV these fluctuations correspond to the formation of polarized tilt walls (PTW’s) from polarized dipole walls (PDW’s). In contrast to the PDW’s, the PTW’s cause a much higher misorientation in between adjacent lattice areas. This transformation, which is the main element of the progressing fragmentation process during large strain deformation, occurs in all metals studied regardless of dislocation mobility and/or lattice type. Approaching higher strains in stage V, however, these parameters gain some importance especially when the deformation occurs in an iterative way. If the mobility is high, marked static recovery takes place between the single deformation passes, which results in decreases of both dislocation density and local internal stress, and no formation of PTW’s is observed.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/126890
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV