Show simple item record

dc.contributor.authorJohn R. Smith
dc.contributor.authorJeffrey B. Lund
dc.contributor.authorRobert K. Galloway
dc.date.accessioned2017-05-09T00:07:14Z
dc.date.available2017-05-09T00:07:14Z
dc.date.copyrightSeptember, 2002
dc.date.issued2002
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26504#146_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/126655
dc.description.abstractThe impact of frictional forces on the overall forces when drilling with a PDC bit has previously been implied by models and by single cutter and bit tests. This report describes new experiments to measure friction between three different bit surface materials and two different rocks over a wide range of normal stresses in up to four different fluids. Polished PDC cutters are shown to have lower frictional forces on the face of the cutter than standard cutters in both water and mineral oil. The measured friction coefficients were generally higher than reported in previous studies.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFriction on PDC Cutters at High Normal Stress
dc.typeJournal Paper
dc.journal.volume124
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.1485745
dc.journal.fristpage146
dc.journal.lastpage153
dc.identifier.eissn1528-8994
dc.keywordsFriction
dc.keywordsStress
dc.keywordsRocks
dc.keywordsPolycrystalline diamond compact bits
dc.keywordsForce
dc.keywordsWater
dc.keywordsFluids AND Drilling
dc.treeJournal of Energy Resources Technology:;2002:;volume( 124 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record