Friction on PDC Cutters at High Normal Stress
View/ Open
Date
2002Author
John R. Smith
Jeffrey B. Lund
Robert K. Galloway
Metadata
Show full item recordAbstract
The impact of frictional forces on the overall forces when drilling with a PDC bit has previously been implied by models and by single cutter and bit tests. This report describes new experiments to measure friction between three different bit surface materials and two different rocks over a wide range of normal stresses in up to four different fluids. Polished PDC cutters are shown to have lower frictional forces on the face of the cutter than standard cutters in both water and mineral oil. The measured friction coefficients were generally higher than reported in previous studies.