• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    A Study of Beta Processing of Ti-6Al-4V: Is it Trivial?

    Thumbnail
    View/Open
    JEMTA8-27021#355_1.pdf (557.9Kb)
    Date
    2001
    Author
    Y. V. R. K. Prasad
    T. Seshacharyulu
    Visiting Scientist
    W. G. Frazier
    Senior Engineer
    S. C. Medeiros
    Research Engineer
    Metadata
    Show full item record
    Abstract
    Deformation of Ti-6Al-4V alloy in the β phase field is generally considered to be trivial since the material is highly workable at these temperatures and does not normally pose problems during processing. In view of this, studies on the hot deformation behavior of β are scanty compared to those on the α−β deformation. This paper is focussed on understanding the β deformation characteristics in Ti-6Al-4V with a view to examine whether such studies help in optimizing the process design and achieving microstructural control. The emphasis has been on the two industrial grades, viz. commercial purity (CP) versus extra-low interstitial (ELI), and also on the effect of starting microstructure (transformed β versus equiaxed α+β). The stress-strain curves obtained in compression exhibited steady-state behavior at strain rates lower than 1 s−1 and oscillatory/softening behavior at higher strain rates. Kinetic analysis of the flow stress data obtained at different temperatures and strain rates has shown that the stress exponent is about 3.6-3.8 and the apparent activation energy is in the range 150-287 kJ/mole, which is comparable to that of self-diffusion in β phase (150 kJ/mol). Dynamic recrystallization (DRX) of β is identified as the microstructural mechanism in all the cases except in ELI grade with transformed β starting structure. The prior β grain size in the DRX region exhibits a good correlation with the Zener-Hollomon parameter. In case of ELI grade, a mechanism of large grained superplasticity involving sliding of prior colony boundaries has been identified. However, deformation close to the transus in ELI grade causes nucleation of voids which may grow during soaking at the deformation temperature under the influence of tensile residual stress. The results clearly show that a study of β deformation mechanisms holds the key during hot working of Ti-6-4. More importantly, the processing schedule used for CP grade Ti-6-4 should not be used for ELI grade to achieve microstructural control and avoid defects.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/125310
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV