Show simple item record

dc.contributor.authorM. L. Bohn
dc.contributor.authorS. G. Xu
dc.contributor.authorK. J. Weinmann
dc.contributor.authorA. Chandra
dc.contributor.authorC. C. Chen
dc.date.accessioned2017-05-09T00:05:01Z
dc.date.available2017-05-09T00:05:01Z
dc.date.copyrightOctober, 2001
dc.date.issued2001
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27024#504_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125288
dc.description.abstractAluminum is expected to gain popularity as material for the bodies of the next generation of lighter and more fuel-efficient vehicles. However, its lower formability compared with that of steel tends to create considerable problems. A controllable restraining force caused by adjusting the penetration of drawbeads can improve the formability. This paper describes the effects of temporal variations in drawbead penetration on the strain distribution in a symmetric stamped part. Comparison of the results of numerical simulations with the corresponding experimental results shows that the predictions of strain distribution on the panel are in very good agreement. Furthermore, forming limit diagram analysis indicates that the active drawbead concept is beneficial to the formability of AA 6111-T4.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleImproving Formability in Sheet Metal Stamping With Active Drawbead Technology
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1395577
dc.journal.fristpage504
dc.journal.lastpage510
dc.identifier.eissn1528-8889
dc.keywordsForce
dc.keywordsAluminum
dc.keywordsFlanges
dc.keywordsTrajectories (Physics)
dc.keywordsFracture (Process)
dc.keywordsSheet metal
dc.keywordsSimulation
dc.keywordsMetal stamping
dc.keywordsFailure
dc.keywordsBlanks
dc.keywordsFinite element methods
dc.keywordsCigarette lighters
dc.keywordsComputer simulation
dc.keywordsVehicles
dc.keywordsFlow (Dynamics)
dc.keywordsMeasurement
dc.keywordsFinite element model
dc.keywordsPresses
dc.keywordsFuels AND Steel
dc.treeJournal of Engineering Materials and Technology:;2001:;volume( 123 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record