• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Improving Formability in Sheet Metal Stamping With Active Drawbead Technology

    Thumbnail
    View/Open
    JEMTA8-27024#504_1.pdf (418.9Kb)
    Date
    2001
    Author
    M. L. Bohn
    S. G. Xu
    K. J. Weinmann
    A. Chandra
    C. C. Chen
    Metadata
    Show full item record
    Abstract
    Aluminum is expected to gain popularity as material for the bodies of the next generation of lighter and more fuel-efficient vehicles. However, its lower formability compared with that of steel tends to create considerable problems. A controllable restraining force caused by adjusting the penetration of drawbeads can improve the formability. This paper describes the effects of temporal variations in drawbead penetration on the strain distribution in a symmetric stamped part. Comparison of the results of numerical simulations with the corresponding experimental results shows that the predictions of strain distribution on the panel are in very good agreement. Furthermore, forming limit diagram analysis indicates that the active drawbead concept is beneficial to the formability of AA 6111-T4.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/125288
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV