Show simple item record

dc.contributor.authorT. J. Nye
dc.date.accessioned2017-05-09T00:05:01Z
dc.date.available2017-05-09T00:05:01Z
dc.date.copyrightOctober, 2001
dc.date.issued2001
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27024#482_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/125285
dc.description.abstractIn stamping, operating costs are dominated by raw material costs, which can typically reach 75 percent of total costs in a stamping facility. In this paper, material utilization efficiency is modeled by considering two primary sources of scrap: material cut away from the exterior of each blank on the strip and off-cuts of unusable narrow strips generated when wide master coils are slit into strips for subsequent stamping. Based on these, layout optimization techniques for minimizing raw material usage are described that predict the optimal blank orientation on the strip and the optimum slitting width for the strip. In addition, methods are given for determining optimal common strip widths for multiple parts, both for dependent and independent demand. These algorithms are ideally suited for incorporation into die design CAE systems.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStamping Blank Optimal Layout and Coil Slitting Widths for Single and Multiple Blanks
dc.typeJournal Paper
dc.journal.volume123
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1395020
dc.journal.fristpage482
dc.journal.lastpage488
dc.identifier.eissn1528-8889
dc.keywordsStrips
dc.keywordsBlanks
dc.keywordsMetal stamping
dc.keywordsAlgorithms AND Raw materials
dc.treeJournal of Engineering Materials and Technology:;2001:;volume( 123 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record