• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Stamping Blank Optimal Layout and Coil Slitting Widths for Single and Multiple Blanks

    Thumbnail
    View/Open
    JEMTA8-27024#482_1.pdf (130.7Kb)
    Date
    2001
    Author
    T. J. Nye
    Metadata
    Show full item record
    Abstract
    In stamping, operating costs are dominated by raw material costs, which can typically reach 75 percent of total costs in a stamping facility. In this paper, material utilization efficiency is modeled by considering two primary sources of scrap: material cut away from the exterior of each blank on the strip and off-cuts of unusable narrow strips generated when wide master coils are slit into strips for subsequent stamping. Based on these, layout optimization techniques for minimizing raw material usage are described that predict the optimal blank orientation on the strip and the optimum slitting width for the strip. In addition, methods are given for determining optimal common strip widths for multiple parts, both for dependent and independent demand. These algorithms are ideally suited for incorporation into die design CAE systems.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/125285
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV