Show simple item record

dc.contributor.authorStuart Barnes
dc.contributor.authorMichael J. Nash
dc.contributor.authorMoh. H. Lim
dc.date.accessioned2017-05-09T00:02:30Z
dc.date.available2017-05-09T00:02:30Z
dc.date.copyrightOctober, 2000
dc.date.issued2000
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27013#379_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/123732
dc.description.abstractA new free-machining additive, MnX, has been reported to improve the machining performance of ferrous powder metallurgy (PM) materials. This work investigated this claim by comparing the performance of three otherwise identical PM materials containing: no additive, conventional manganese sulphide (MnS) additions and the new MnX additive. A turning operation and cutting speeds of 100–250 m/min were used during which cutting forces, tool wear and surface finish were measured. The MnX material was found to exhibit superior performance. However, this was most noticeable at higher cutting speeds and at the lower cutting speeds, differences in performance were substantially reduced. [S0094-4289(00)02004-1]
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMachining Performance of PM Material Containing MnX Additives1
dc.typeJournal Paper
dc.journal.volume122
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1288924
dc.journal.fristpage379
dc.journal.lastpage383
dc.identifier.eissn1528-8889
dc.keywordsWear
dc.keywordsMachining
dc.keywordsCutting AND Turning
dc.treeJournal of Engineering Materials and Technology:;2000:;volume( 122 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record