• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Machining Performance of PM Material Containing MnX Additives1

    Thumbnail
    View/Open
    JEMTA8-27013#379_1.pdf (489.5Kb)
    Date
    2000
    Author
    Stuart Barnes
    Michael J. Nash
    Moh. H. Lim
    Metadata
    Show full item record
    Abstract
    A new free-machining additive, MnX, has been reported to improve the machining performance of ferrous powder metallurgy (PM) materials. This work investigated this claim by comparing the performance of three otherwise identical PM materials containing: no additive, conventional manganese sulphide (MnS) additions and the new MnX additive. A turning operation and cutting speeds of 100–250 m/min were used during which cutting forces, tool wear and surface finish were measured. The MnX material was found to exhibit superior performance. However, this was most noticeable at higher cutting speeds and at the lower cutting speeds, differences in performance were substantially reduced. [S0094-4289(00)02004-1]
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/123732
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV