Show simple item record

dc.contributor.authorJohn D. Bernardin
dc.contributor.authorIssam Mudawar
dc.date.accessioned2017-05-08T23:50:25Z
dc.date.available2017-05-08T23:50:25Z
dc.date.copyrightJanuary, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26976#127_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117088
dc.description.abstractRepeated heat-quench cycles of Al-1100 samples resulted in increased surface roughness and corresponding shifts in the temperature-time cooling curve towards shorter overall quench periods. Three different types of initial surface roughness were applied to the test samples: polished, particle blasted, and milled finishes. For each of the three test surfaces, cooling curve shifts during repeated heat-quench cycles were accompanied by surface roughening, the shift was smallest with the milled sample. The surface roughness was examined with the aid of scanning electron microscopy, surface contact profilometry, and X-ray photoelectron spectroscopy. Surface profiles obtained via the profilometer revealed, on a relative basis, significant changes in surface roughness on the polished and particle blasted surfaces but not on the milled (roughest) surface. The roughening was the result of (a) hydrogen diffusion associated with oxidation, (b) oxidation buildup, and, to a lesser extent, (c) expulsion of impurities along dendrite boundaries. The hydrogen diffusion caused localized pressure buildup within the surface and along grain boundaries resulting in the formation of both microscopic (1 to 10 μm) features on the polished and particle blasted surfaces and relatively large (20 to 1000 μm) bumps and blisters on the particle blasted surface. It is shown how these wide spectrum surface roughness features affect cooling rate by (a) raising the Leidenfrost temperature separating the film and transition boiling regimes, (b) increasing the number of boiling sites on the quenched surface, and (c) altering the impact dynamics of the spray drops.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Experimental Investigation Into the Relationship Between Temperature-Time History and Surface Roughness in the Spray Quenching of Aluminum Parts
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2805925
dc.journal.fristpage127
dc.journal.lastpage134
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsSurface roughness
dc.keywordsAluminum
dc.keywordsQuenching (Metalworking)
dc.keywordsSprays
dc.keywordsParticulate matter
dc.keywordsPolishing
dc.keywordsCooling
dc.keywordsHeat
dc.keywordsDiffusion (Physics)
dc.keywordsBoiling
dc.keywordsCycles
dc.keywordsHydrogen
dc.keywordsoxidation
dc.keywordsScanning electron microscopy
dc.keywordsGrain boundaries
dc.keywordsFinishes
dc.keywordsPhotoelectron spectroscopy
dc.keywordsDrops
dc.keywordsX-rays
dc.keywordsSpectra (Spectroscopy)
dc.keywordsDynamics (Mechanics) AND Pressure
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record