• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    An Experimental Investigation Into the Relationship Between Temperature-Time History and Surface Roughness in the Spray Quenching of Aluminum Parts

    Thumbnail
    View/Open
    JEMTA8-26976#127_1.pdf (1.220Mb)
    Date
    1996
    Author
    John D. Bernardin
    Issam Mudawar
    Metadata
    Show full item record
    Abstract
    Repeated heat-quench cycles of Al-1100 samples resulted in increased surface roughness and corresponding shifts in the temperature-time cooling curve towards shorter overall quench periods. Three different types of initial surface roughness were applied to the test samples: polished, particle blasted, and milled finishes. For each of the three test surfaces, cooling curve shifts during repeated heat-quench cycles were accompanied by surface roughening, the shift was smallest with the milled sample. The surface roughness was examined with the aid of scanning electron microscopy, surface contact profilometry, and X-ray photoelectron spectroscopy. Surface profiles obtained via the profilometer revealed, on a relative basis, significant changes in surface roughness on the polished and particle blasted surfaces but not on the milled (roughest) surface. The roughening was the result of (a) hydrogen diffusion associated with oxidation, (b) oxidation buildup, and, to a lesser extent, (c) expulsion of impurities along dendrite boundaries. The hydrogen diffusion caused localized pressure buildup within the surface and along grain boundaries resulting in the formation of both microscopic (1 to 10 μm) features on the polished and particle blasted surfaces and relatively large (20 to 1000 μm) bumps and blisters on the particle blasted surface. It is shown how these wide spectrum surface roughness features affect cooling rate by (a) raising the Leidenfrost temperature separating the film and transition boiling regimes, (b) increasing the number of boiling sites on the quenched surface, and (c) altering the impact dynamics of the spray drops.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/117088
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV