Show simple item record

dc.contributor.authorDaniel O’Hare Adams
dc.contributor.authorMichael W. Hyer
dc.date.accessioned2017-05-08T23:50:23Z
dc.date.available2017-05-08T23:50:23Z
dc.date.copyrightJanuary, 1996
dc.date.issued1996
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26976#63_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/117078
dc.description.abstractA finite element analysis was used to investigate layer waviness effects in flat compression-loaded composite laminates. Stress distributions in the vicinity of the layer waves as well as the locations and modes of failure were investigated. Two layer wave geometries were considered, each modeled within an otherwise wave-free thermoplastic composite laminate. These two wave geometries, classified as moderate and severe, corresponded to layer waves fabricated in actual laminates and tested under uniaxial compression loading. Material nonlinearities obtained from intralaminar shear and 0 and 90 deg tension and compression testing were incorporated into the analysis. The nonlinearity observed in the intralaminar shear stress-strain behavior was assumed to be valid for interlaminar shear stress-strain behavior, and the nonlinearity observed in the 90 deg tension and compression stress-strain behavior was assumed to be valid for interlaminar normal stress-strain behavior. Failure was predicted using a maximum stress failure theory. An interlaminar tension failure was predicted for the severe layer wave geometry, producing a large compression strength reduction in comparison to the wave-free laminate. Fiber compression failure was predicted for the moderate layer wave, producing only a slight compression strength reduction. Although significant material nonlinearity was present in the interlaminar compression and shear response of the material, the inclusion of material nonlinearity produced only slight decreases in predicted compression strengths relative to predictions based on linear material behavior.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnalysis of Layer Waviness in Flat Compression-Loaded Thermoplastic Composite Laminates
dc.typeJournal Paper
dc.journal.volume118
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2805935
dc.journal.fristpage63
dc.journal.lastpage70
dc.identifier.eissn1528-8889
dc.keywordsLaminates
dc.keywordsThermoplastic composites
dc.keywordsCompression
dc.keywordsWaves
dc.keywordsStress
dc.keywordsFailure
dc.keywordsShear (Mechanics)
dc.keywordsTension
dc.keywordsCompressive strength
dc.keywordsFinite element analysis
dc.keywordsTesting
dc.keywordsComposite materials
dc.keywordsFibers AND Geometry
dc.treeJournal of Engineering Materials and Technology:;1996:;volume( 118 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record