• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Analysis of Layer Waviness in Flat Compression-Loaded Thermoplastic Composite Laminates

    Thumbnail
    View/Open
    JEMTA8-26976#63_1.pdf (1.045Mb)
    Date
    1996
    Author
    Daniel O’Hare Adams
    Michael W. Hyer
    Metadata
    Show full item record
    Abstract
    A finite element analysis was used to investigate layer waviness effects in flat compression-loaded composite laminates. Stress distributions in the vicinity of the layer waves as well as the locations and modes of failure were investigated. Two layer wave geometries were considered, each modeled within an otherwise wave-free thermoplastic composite laminate. These two wave geometries, classified as moderate and severe, corresponded to layer waves fabricated in actual laminates and tested under uniaxial compression loading. Material nonlinearities obtained from intralaminar shear and 0 and 90 deg tension and compression testing were incorporated into the analysis. The nonlinearity observed in the intralaminar shear stress-strain behavior was assumed to be valid for interlaminar shear stress-strain behavior, and the nonlinearity observed in the 90 deg tension and compression stress-strain behavior was assumed to be valid for interlaminar normal stress-strain behavior. Failure was predicted using a maximum stress failure theory. An interlaminar tension failure was predicted for the severe layer wave geometry, producing a large compression strength reduction in comparison to the wave-free laminate. Fiber compression failure was predicted for the moderate layer wave, producing only a slight compression strength reduction. Although significant material nonlinearity was present in the interlaminar compression and shear response of the material, the inclusion of material nonlinearity produced only slight decreases in predicted compression strengths relative to predictions based on linear material behavior.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/117078
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV