Show simple item record

dc.contributor.authorA. K. Murthy
dc.contributor.authorS. D. Brown
dc.contributor.authorK. Komvopoulos
dc.date.accessioned2017-05-08T23:32:47Z
dc.date.available2017-05-08T23:32:47Z
dc.date.copyrightApril, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26934#164_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/107010
dc.description.abstractA new concept of a multi-layered ceramic coating consisting of a porcelain enamel bond interlayer with thermal expansion characteristics tailored to match those of a cast iron substrate and a plasma-sprayed wear-resistant surface layer of chromium oxide, chromium carbide, or partially stabilized zirconia was investigated. Flat substrates of grit-blasted and surface-treated cast iron were slurry sprayed with a finely ground glass frit mixed with isopropyl alcohol and water. Subsequently, the specimens were dried in an oven before firing at 1023 K to produce a smooth, dense, and strongly adherent enamel coating 75 to 100 μm thick. Wear-resistant coatings of oxides and carbides with varying particle sizes and powder densities were then thermally sprayed, by means of a plasma spray gun, at controlled power ratings and gas flow rates. The produced ceramic coatings were subsequently ground to a thickness of about 120 μm. Adherence testing by the tensile pull-off technique revealed high interfacial strength between the enamel coating and the substrate resulting from enhanced chemical interdiffusion and mechanical interlocking. Unlubricated sliding wear experiments using a ball-on-flat tribotester and tungsten carbide balls as sliders demonstrated low initial and moderately high steady-state friction coefficients. Optical and scanning electron microscopy and surface profilometry of the tested ceramic-coated specimens verified that surface damage and wear rate were negligibly small. The important role of the main process parameters on the interfacial adherence and uniformity of the enamel and ceramic layers and the potentiality of the developed processes in the deposition of relatively low-friction and wear-resistant multi-layered thick ceramic coatings are discussed in the context of the obtained results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleProcessing and Characterization of Multi-Layered Wear-Resistant Ceramic Coatings
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903303
dc.journal.fristpage164
dc.journal.lastpage174
dc.identifier.eissn1528-8889
dc.keywordsWear
dc.keywordsCeramic coatings
dc.keywordsEnameling
dc.keywordsPlasmas (Ionized gases)
dc.keywordsCoating processes
dc.keywordsCeramics
dc.keywordsFriction
dc.keywordsCast iron
dc.keywordsPorcelain
dc.keywordsThermal expansion
dc.keywordsParticulate matter
dc.keywordsGround glass
dc.keywordsScanning electron microscopy
dc.keywordsSlurries
dc.keywordsSprays
dc.keywordsTesting
dc.keywordsEthanol
dc.keywordsFiring (materials)
dc.keywordsOvens
dc.keywordsSteady state
dc.keywordsThickness
dc.keywordsTungsten
dc.keywordsWater AND Gas flow
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record