Show simple item record

dc.contributor.authorK. Komvopoulos
dc.contributor.authorK. Nagarathnam
dc.date.accessioned2017-05-08T23:32:47Z
dc.date.available2017-05-08T23:32:47Z
dc.date.copyrightApril, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26934#131_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/107006
dc.description.abstractThe feasibility of laser cladding as a surface modification process was experimentally investigated. Emphasis was placed on identification of the effects of independent critical process parameters such as laser power, process speed (interaction time), and feed rate of cladding powder mixture on the microstructure, compositional homogeneity, geometry (e.g., thickness and width), and mechanical properties of the developed coatings. Rapidly solidified coatings metallurgically bonded to AISI 1018 steel substrates were formed in situ by using a 10 kW continuous wave CO2 laser to melt a thin layer of the substrate as well as a powder mixture consisting of Fe, Cr, C, and W with a weight ratio of 10:5:1:1 delivered to the substrate by means of blown shielding gas and a pneumatic screw feed system. Various diagnostic methods, indentation hardness measurements, and scratch-resistance testing of the laser-cladded coating materials revealed a high degree of grain refinement, increased solid solubility and uniform distribution of alloying elements, high hardness, and appreciable resistance against plastic shear deformation when the important process parameters were optimized. Microstructure studies demonstrated that coatings with very fine or relatively coarse dendritic, feathery, and particulate type microstructures were obtained, depending on the processing conditions. This investigation verified that due to the inherent rapid solidification and high concentration of key elements in the surface, hard coating materials of novel microstructures and physical properties which can be tailored to the surface requirements of the application can be produced with minimum dilution and thermal distortion. Implications of the laser cladding process in tribological applications are also interpreted qualitatively in light of the obtained results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleProcessing and Characterization of Laser-Cladded Coating Materials
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903299
dc.journal.fristpage131
dc.journal.lastpage143
dc.identifier.eissn1528-8889
dc.keywordsLasers
dc.keywordsCoating processes
dc.keywordsCoatings
dc.keywordsCladding systems (Building)
dc.keywordsMixtures
dc.keywordsElectrical resistance
dc.keywordsWaves
dc.keywordsMechanical properties
dc.keywordsWeight (Mass)
dc.keywordsTribology
dc.keywordsSteel
dc.keywordsMeasurement
dc.keywordsParticulate matter
dc.keywordsScrews
dc.keywordsShear deformation
dc.keywordsThickness
dc.keywordsSolidification
dc.keywordsTesting AND Geometry
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record