• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Processing and Characterization of Laser-Cladded Coating Materials

    Thumbnail
    View/Open
    JEMTA8-26934#131_1.pdf (5.015Mb)
    Date
    1990
    Author
    K. Komvopoulos
    K. Nagarathnam
    Metadata
    Show full item record
    Abstract
    The feasibility of laser cladding as a surface modification process was experimentally investigated. Emphasis was placed on identification of the effects of independent critical process parameters such as laser power, process speed (interaction time), and feed rate of cladding powder mixture on the microstructure, compositional homogeneity, geometry (e.g., thickness and width), and mechanical properties of the developed coatings. Rapidly solidified coatings metallurgically bonded to AISI 1018 steel substrates were formed in situ by using a 10 kW continuous wave CO2 laser to melt a thin layer of the substrate as well as a powder mixture consisting of Fe, Cr, C, and W with a weight ratio of 10:5:1:1 delivered to the substrate by means of blown shielding gas and a pneumatic screw feed system. Various diagnostic methods, indentation hardness measurements, and scratch-resistance testing of the laser-cladded coating materials revealed a high degree of grain refinement, increased solid solubility and uniform distribution of alloying elements, high hardness, and appreciable resistance against plastic shear deformation when the important process parameters were optimized. Microstructure studies demonstrated that coatings with very fine or relatively coarse dendritic, feathery, and particulate type microstructures were obtained, depending on the processing conditions. This investigation verified that due to the inherent rapid solidification and high concentration of key elements in the surface, hard coating materials of novel microstructures and physical properties which can be tailored to the surface requirements of the application can be produced with minimum dilution and thermal distortion. Implications of the laser cladding process in tribological applications are also interpreted qualitatively in light of the obtained results.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/107006
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV