| dc.contributor.author | H. Vossoughi | |
| dc.contributor.author | K. Soudki | |
| dc.contributor.author | R. N. White | |
| dc.contributor.author | A. R. Ingraffea | |
| dc.contributor.author | M. Sansalone | |
| dc.date.accessioned | 2017-05-08T23:30:50Z | |
| dc.date.available | 2017-05-08T23:30:50Z | |
| dc.date.copyright | August, 1989 | |
| dc.date.issued | 1989 | |
| dc.identifier.issn | 0094-9930 | |
| dc.identifier.other | JPVTAS-28311#259_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/105870 | |
| dc.description.abstract | The use of cold-bent plates, instead of welded corner joints, in the fabrication of pressure vessels can reduce production costs. The cold-bending operation is relatively easy, inexpensive, and requires minimum quality control. The attractiveness of using cold-bent plates as a potential substitute for plates with welded corner joints motivated the fatigue study described here. Fatigue test resutls are reported for nineteen 25-mm thick HY80 and HY100 steel plates, cold-bent to a nominal bend angle of 90 deg and an R /t (inner bend radius/thickness) of 1.5, and ten 25-mm thick HY80 welded corner joints. Testing was performed under zero-to-tension loading (stress ratio R = 0) at room temperature and at a frequency of 4 Hz on specimens that retained the actual cold-bending-induced residual stresses. These test results indicate that the cold-bent plates may be a good alternative to welded corner joints for cyclic loading histories. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Fatigue of Thick Steel Plates Bent to a Low R/t Ratio | |
| dc.type | Journal Paper | |
| dc.journal.volume | 111 | |
| dc.journal.issue | 3 | |
| dc.journal.title | Journal of Pressure Vessel Technology | |
| dc.identifier.doi | 10.1115/1.3265673 | |
| dc.journal.fristpage | 259 | |
| dc.journal.lastpage | 265 | |
| dc.identifier.eissn | 1528-8978 | |
| dc.keywords | Steel | |
| dc.keywords | Plates (structures) | |
| dc.keywords | Fatigue | |
| dc.keywords | Corners (Structural elements) | |
| dc.keywords | Temperature | |
| dc.keywords | Testing | |
| dc.keywords | Fatigue testing | |
| dc.keywords | Tension | |
| dc.keywords | Thickness | |
| dc.keywords | Quality control | |
| dc.keywords | Manufacturing | |
| dc.keywords | Pressure vessels | |
| dc.keywords | Residual stresses AND Stress | |
| dc.tree | Journal of Pressure Vessel Technology:;1989:;volume( 111 ):;issue: 003 | |
| dc.contenttype | Fulltext | |