• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Fatigue of Thick Steel Plates Bent to a Low R/t Ratio

    Thumbnail
    View/Open
    JPVTAS-28311#259_1.pdf (1.425Mb)
    Date
    1989
    Author
    H. Vossoughi
    K. Soudki
    R. N. White
    A. R. Ingraffea
    M. Sansalone
    Metadata
    Show full item record
    Abstract
    The use of cold-bent plates, instead of welded corner joints, in the fabrication of pressure vessels can reduce production costs. The cold-bending operation is relatively easy, inexpensive, and requires minimum quality control. The attractiveness of using cold-bent plates as a potential substitute for plates with welded corner joints motivated the fatigue study described here. Fatigue test resutls are reported for nineteen 25-mm thick HY80 and HY100 steel plates, cold-bent to a nominal bend angle of 90 deg and an R /t (inner bend radius/thickness) of 1.5, and ten 25-mm thick HY80 welded corner joints. Testing was performed under zero-to-tension loading (stress ratio R = 0) at room temperature and at a frequency of 4 Hz on specimens that retained the actual cold-bending-induced residual stresses. These test results indicate that the cold-bent plates may be a good alternative to welded corner joints for cyclic loading histories.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/105870
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV