• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    The Effect of Several Finishing Processes on the Fatigue Resistance of Hole Surfaces

    Thumbnail
    View/Open
    JEMTA8-26927#71_1.pdf (329.9Kb)
    Date
    1989
    Author
    M. O. Lai
    A. Y. C. Nee
    Metadata
    Show full item record
    Abstract
    This investigation examines the effects of different finishing processes on the fatigue life of premachined holes in Assab 760 steel plates. The finishing processes studied were reaming, ballizing, and emery polishing. A general decrease in fatigue life with increase in surface roughness is observed for all the processes employed. In comparing the different processes, for a constant surface roughness, polishing is generally found to give the longest fatigue life while ballizing, in spite of the greater compressive residual stresses induced on the surface of the finished hole, the shortest. The surprising phenomenon was found to be attributed to the amount of plastic deformation occurred before fatigue loading. For Assab 760 steel, a prestrain in the radial direction of less than about 2.5 percent appeared to reduce the fatigue resistance of the material.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/105522
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV