Show simple item record

dc.contributor.authorD. A. Stephensen
dc.date.accessioned2017-05-08T23:30:11Z
dc.date.available2017-05-08T23:30:11Z
dc.date.copyrightApril, 1989
dc.date.issued1989
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26928#210_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105509
dc.description.abstractWidely applicable machining simulation programs require reliable cutting force estimates, which currently can be obtained only from process-dependent machinability databases. The greatest obstacle to developing a more basic, efficient approach is a lack of understanding of material yield and frictional behavior under the unique deformation and frictional conditions of cutting. This paper describes a systematic method of specifying yield stress and friction properties needed as inputs to process-independent cutting force models. Statistically designed end turning tests are used to generate cutting force and chip thickness data for a mild steel and an aluminum alloy over a wide range of cutting conditions. Empirical models are fit for the cutting force and model-independent material parameters such as the tool-chip friction coefficient and shear stress on the shear plane. Common material yield behavior assumptions are examined in light of correlations between these parameters. Results show no physically meaningful correlation between geometric shear stress and strain measures, a weak correlation between geometric stress and strain rate measures, and a strong correlation between material properties and input variables such as cutting speed and rake angle. An upper bound model is used to fit four- and five-parameter polynomial strain-rate sensitive constitutive equations to the data. Drilling torques calculated using this model and an empirical turning force model agree reasonably well with measured values for the same material combination, indicating that end turning test results can be used to estimate mean loads in a more complicated process.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMaterial Characterization for Metal-Cutting Force Modeling
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226456
dc.journal.fristpage210
dc.journal.lastpage219
dc.identifier.eissn1528-8889
dc.keywordsForce
dc.keywordsMetal cutting
dc.keywordsModeling
dc.keywordsCutting
dc.keywordsStress
dc.keywordsShear (Mechanics)
dc.keywordsFriction
dc.keywordsMachining
dc.keywordsSteel
dc.keywordsAluminum alloys
dc.keywordsDrilling
dc.keywordsSimulation
dc.keywordsDeformation
dc.keywordsMaterials properties
dc.keywordsConstitutive equations
dc.keywordsDatabases
dc.keywordsMachinability
dc.keywordsPolynomials
dc.keywordsThickness AND Yield stress
dc.treeJournal of Engineering Materials and Technology:;1989:;volume( 111 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record