• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Material Characterization for Metal-Cutting Force Modeling

    Thumbnail
    View/Open
    JEMTA8-26928#210_1.pdf (891.0Kb)
    Date
    1989
    Author
    D. A. Stephensen
    Metadata
    Show full item record
    Abstract
    Widely applicable machining simulation programs require reliable cutting force estimates, which currently can be obtained only from process-dependent machinability databases. The greatest obstacle to developing a more basic, efficient approach is a lack of understanding of material yield and frictional behavior under the unique deformation and frictional conditions of cutting. This paper describes a systematic method of specifying yield stress and friction properties needed as inputs to process-independent cutting force models. Statistically designed end turning tests are used to generate cutting force and chip thickness data for a mild steel and an aluminum alloy over a wide range of cutting conditions. Empirical models are fit for the cutting force and model-independent material parameters such as the tool-chip friction coefficient and shear stress on the shear plane. Common material yield behavior assumptions are examined in light of correlations between these parameters. Results show no physically meaningful correlation between geometric shear stress and strain measures, a weak correlation between geometric stress and strain rate measures, and a strong correlation between material properties and input variables such as cutting speed and rake angle. An upper bound model is used to fit four- and five-parameter polynomial strain-rate sensitive constitutive equations to the data. Drilling torques calculated using this model and an empirical turning force model agree reasonably well with measured values for the same material combination, indicating that end turning test results can be used to estimate mean loads in a more complicated process.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/105509
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV