| contributor author | A. S. Korhonen | |
| date accessioned | 2017-05-08T23:13:49Z | |
| date available | 2017-05-08T23:13:49Z | |
| date copyright | February, 1982 | |
| date issued | 1982 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27695#29_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/96102 | |
| description abstract | A method for estimating the maximum drawing force in the deep drawing of cylindrical cups with flat-nosed punch is developed. The criterion is obtained using the load maximum principle for localization of the plastic flow. The criterion is then applied in an attempt to develop a simple and practically applicable method for deep drawing force evaluation. Simple charts are presented to obtain the maximum drawing force as a function of the tooling geometry and anisotropy for steel, brass and stainless steel. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Drawing Force in Deep Drawing of Cylindrical Cup With Flat-Nosed Punch | |
| type | Journal Paper | |
| journal volume | 104 | |
| journal issue | 1 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3185794 | |
| journal fristpage | 29 | |
| journal lastpage | 37 | |
| identifier eissn | 1528-8935 | |
| keywords | Force | |
| keywords | Deformation | |
| keywords | Brass (Metal) | |
| keywords | Steel | |
| keywords | Stress | |
| keywords | Anisotropy | |
| keywords | Geometry | |
| keywords | Tooling AND Stainless steel | |
| tree | Journal of Manufacturing Science and Engineering:;1982:;volume( 104 ):;issue: 001 | |
| contenttype | Fulltext | |
