| contributor author | J. F. Thorpe | |
| date accessioned | 2017-05-08T23:12:20Z | |
| date available | 2017-05-08T23:12:20Z | |
| date copyright | September, 1963 | |
| date issued | 1963 | |
| identifier issn | 0098-2202 | |
| identifier other | JFEGA4-27251#417_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/95234 | |
| description abstract | The problem considered is that of flow in the two parallel channels formed by the introduction of a long thin plate into a duct of uniform rectangular cross section. The plate is slightly inclined and does not, in general, span the channel so that transverse flow may occur. The flow is described by applying the one-dimensional approximation. Boundary conditions were established by regarding the stagnation streamline as defining two separate channels upstream of the plate leading edge. The solution was then obtained numerically with an IBM 650 computer. Computed hydraulic parameters were in good agreement with those obtained experimentally. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Hydraulic Flow in Coupled Parallel Channels of Varying Cross-Sectional Area | |
| type | Journal Paper | |
| journal volume | 85 | |
| journal issue | 3 | |
| journal title | Journal of Fluids Engineering | |
| identifier doi | 10.1115/1.3656627 | |
| journal fristpage | 417 | |
| journal lastpage | 423 | |
| identifier eissn | 1528-901X | |
| keywords | Channels (Hydraulic engineering) | |
| keywords | Hydraulic flow | |
| keywords | Flow (Dynamics) | |
| keywords | Computers | |
| keywords | Approximation | |
| keywords | Boundary-value problems AND Ducts | |
| tree | Journal of Fluids Engineering:;1963:;volume( 085 ):;issue: 003 | |
| contenttype | Fulltext | |
