| contributor author | K. Mitome | |
| date accessioned | 2017-05-08T23:11:33Z | |
| date available | 2017-05-08T23:11:33Z | |
| date copyright | November, 1981 | |
| date issued | 1981 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27693#452_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/94787 | |
| description abstract | First this paper discusses an imaginary generating rack when an involute hob is used, on the basis of the theoretical analysis in Part 1 of this paper. Next a conical involute gear generated by the rack is analyzed. Finally, practical hobbing is discussed. Some test gears are cut and inspected. And is confirmed propriety of considering the ideal conical gear defined in Part 1 as the representative of the gear cut by the table sliding taper hobbing. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Table Sliding Taper Hobbing of Conical Gear Using Cylindrical Hob. Part 2: Hobbing of Conical Involute Gear | |
| type | Journal Paper | |
| journal volume | 103 | |
| journal issue | 4 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3184511 | |
| journal fristpage | 452 | |
| journal lastpage | 455 | |
| identifier eissn | 1528-8935 | |
| keywords | Gears AND Theoretical analysis | |
| tree | Journal of Manufacturing Science and Engineering:;1981:;volume( 103 ):;issue: 004 | |
| contenttype | Fulltext | |
