| contributor author | E. M. Schulson | |
| contributor author | D. M. Norman | |
| date accessioned | 2017-05-08T23:09:19Z | |
| date available | 2017-05-08T23:09:19Z | |
| date copyright | February, 1980 | |
| date issued | 1980 | |
| identifier issn | 1087-1357 | |
| identifier other | JMSEFK-27683#20_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/93593 | |
| description abstract | Tool-life curves have been obtained for an experimental, high-strength Zr 8.6 wt% Al alloy, in two metallurgical states (two-phase Zr2 Al/Zr and single phase Zr3 Al). Below a critical cutting speed, the data obey the Taylor expression V τn = C, where V is the cutting speed, τ is tool-life and n and C are constants. This expression is used to determine the cutting conditions which optimize the rate of metal removal during turning operations. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | The Machinability of a High Strength Zirconium 8.6 Wt% Aluminum Alloy: Tool-Life Curves | |
| type | Journal Paper | |
| journal volume | 102 | |
| journal issue | 1 | |
| journal title | Journal of Manufacturing Science and Engineering | |
| identifier doi | 10.1115/1.3183823 | |
| journal fristpage | 20 | |
| journal lastpage | 24 | |
| identifier eissn | 1528-8935 | |
| keywords | Aluminum alloys | |
| keywords | Machinability | |
| keywords | Zirconium | |
| keywords | Cutting | |
| keywords | Machining AND Turning | |
| tree | Journal of Manufacturing Science and Engineering:;1980:;volume( 102 ):;issue: 001 | |
| contenttype | Fulltext | |
