Hydraulic Conductivity Measurement from On-the-Fly uCPT Sounding and from VisCPT

Abstract

Detailed profiles of hydraulic conductivity are recovered from the deployment of direct-push permeameters at the Geohydrologic Experimental and Monitoring Site, Kansas. Measurements with thin tapered tips, and with standard cone penetration test (uCPT) tips, show only minor differences, suggesting that tip-local disturbance effects are small, and that routine uCPT measurements are therefore representative of pristine conditions. Permeameter measurements are correlated against closely deployed uCPT measurements, estimates of hydraulic conductivity from uCPT sounding correlations, and from grain size correlations derived from both vision CPT (VisCPT) and from cone metrics. On-the-fly evaluations of hydraulic conductivity require that the tip-local pressure field is both steady and partially drained. Continuous penetration is shown to yield pore pressures sufficiently close to steady to enable conductivities to be directly determined. Cone metrics of cone resistance, sleeve friction, and pore pressure ratio are shown to be sufficient to discriminate between partially drained and undrained behavior, and therefore to define the permissible regime where conductivities may be determined from uCPT sounding data. Estimates of hydraulic conductivities from uCPT sounding data are shown to correlate with independently measured magnitudes of hydraulic conductivity recovered using the permeameter tests. However, most of hydraulic conductivities from the permeameter tests (