| description abstract | The design of grippers for the agro-industry is challenging. To be cost-effective, the picked object should be moved around fast requiring a firm grip on the fruit of different hardnesses, shapes, and sizes without causing damage. This article presents a self-adaptive flexure-based gripper design optimized for high acceleration loads. A main novelty is that it is actuated through a push–pull flexure that is loaded in tension when the gripper closes, allowing it to handle high actuation forces without the risk of buckling. To create a robust gripper that can handle relatively high loads, flexures are used that are reinforced and have a thickness variation over the length. The optimal thickness distribution of these flexures is derived analytically to facilitate the design process. The derived principles are generally applicable to flexure hinges. The resulting advanced cartwheel flexure joint, as used in this gripper, has a 2.5 times higher support stiffness and a 1.5 times higher buckling load when compared to a conventional cartwheel joint of the same size and actuation stiffness. The PP-gripper is numerically optimized for a high pull-out force, using analytical design insights as a starting point. The gripper can grip circular objects with radii between 30 and 40 mm. The pull-out force is 21.4 N, with a maximum actuation force of 100 N. Good correspondence is found between the geometric design approach, the numerically optimized design, and the results of the experimental validation. | |
