Show simple item record

contributor authorBarman, N.
contributor authorAleria, A.
contributor authorBera, P.
date accessioned2024-04-24T22:29:41Z
date available2024-04-24T22:29:41Z
date copyright3/15/2024 12:00:00 AM
date issued2024
identifier issn2832-8450
identifier otherht_146_07_072701.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4295325
description abstractIn this article, the linear stability of nonisothermal plane Couette flow (NPCF) in an anisotropic and inhomogeneous porous layer underlying a fluid layer is investigated. The Darcy model is utilized to describe the flow in the porous layer. The stability analysis indicates that the introduction of media-anisotropy (K*) and media-inhomogeneity (in terms of inhomogeneity parameter A) still renders the isothermal plane Couette flow (IPCF) in such superposed fluid-porous systems unconditionally stable. For NPCF, three different modes, unimodal (porous or fluid mode), bimodal (porous and fluid mode) and trimodal (porous, fluid and porous mode), are observed along the neutral stability curves and characterized by the secondary flow patterns. It has been found that the instability of the fluid-porous system increases on increasing the media permeability and inhomogeneity along the vertical direction. Contrary to natural convection, at d̂=0.2 (d̂=depth of fluid layer/depth of porous layer) and K*=1, in which the critical wavelength shows both increasing and decreasing characteristics with increasing values of A (0≤A≤5), here in the present study, the same continuously decreases with increasing values of A. Finally, scale analysis indicates that the onset of natural convection requires a relatively higher temperature difference (ΔT) between lower and upper plates in the presence of Couette flow. However, by including media anisotropy and inhomogeneity in the porous media, the system becomes unstable even for a small critical temperature difference of about 2 °C.
publisherThe American Society of Mechanical Engineers (ASME)
titleNon-Isothermal Plane Couette Flow and Its Stability in an Anisotropic and Inhomogeneous Porous Layer Underlying a Fluid Layer Saturated by Water
typeJournal Paper
journal volume146
journal issue7
journal titleASME Journal of Heat and Mass Transfer
identifier doi10.1115/1.4064736
journal fristpage72701-1
journal lastpage72701-13
page13
treeASME Journal of Heat and Mass Transfer:;2024:;volume( 146 ):;issue: 007
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record