| description abstract | The reliability of the prediction model and test scheme for the positioning accuracy of the cycloid reducer is very important. This paper proposes an efficient bidirectional drive tooth contact analysis (BDTCA) model that can simultaneously analyze the forward transmission error (TE), the reverse TE, and the global lost motion (GLM) of a cycloid drive, considering a variety of manufacturing and assembly errors (including pin assembly error). The results of the BDTCA case studies show that the sensitivity of the pin radius error to the GLM considering pin assembly error is twice that of the sensitivity without considering pin assembly error. Therefore, the influence of pin assembly error on the GLM cannot be ignored. The equivalent error model for BDTCA is established based on Latin hypercube sampling and template measurement, and the positioning accuracy of 50,000 reducer virtual prototypes is predicted. According to the positioning accuracy requirements, the tolerance allocation is optimized by using the discrete particle swarm optimization algorithm, and the qualified rate after optimization is significantly improved. A bidirectional drive test (BDT) scheme is proposed according to the BDTCA model. By comparing with the traditional hysteresis curve test, the superiority of the BDT scheme and the rationality of the tolerance allocation optimization are proved. The sensitivity of the pin radius error to the GLM is obtained through a comparison BDT, which verifies the correctness of the BDTCA model considering pin assembly error. This BDTCA model provides more reliable theoretical guidance for the design and manufacture of cycloid reducers. | |
