| description abstract | The blade leading edge is a design variable that can affect the local flow patterns and pressure peaks, implying a direct effect on the cavitation performance. This study was conducted to analyze the effect of the blade leading edge shape on the cavitation and noncavitation states. A total of four sets, including the square shape, were selected under the definition of ellipse ratio, and the main focus was on the cavitation state rather than the noncavitation state. In the noncavitation state, the square set denoted a remarkable negative influence, while the other three sets obtained almost the same performance despite different ellipse ratios. In the cavitation state, the square set obtained a relatively low net positive suction head required, related to the inlet flow pattern with the cloud cavity. The other three sets contained the sheet cavity, and their suction performance tended to improve as the cavity blockage decreased. As a parallel focus, an in-depth analysis of cavitation surge and pressure gain was presented with the head drop slope for the other three ellipse sets. The numerical results included the off-design flow rate points and were validated through an experimental test. | |
