| description abstract | Numerical and experimental analyses of the static and dynamic characteristics of the liquid annular seals with axially partial helical grooves were conducted to investigate the effects of the axial length gal of a helically grooved section in a seal stator. The numerical solution and experimental procedures were applied in the same manner as in previous studies on through-helically grooved seals, wherein the grooves extend across the seal length. The numerical results qualitatively agreed with the experimental results, demonstrating the validity of the numerical analysis. The leakage flow rate Q was lower in the partially helically grooved seals than that of conventional through-helically grooved seals across a small range of rotor spinning velocities. In contrast, the reduction in Q due to the pumping effect caused by the spin of the rotor diminished with the decrease in gal. For a small concentric whirling motion of the rotor, the radial dynamic reaction force Fr and magnitude of variation in the tangential dynamic reaction force Ft with the whirling angular velocity increased with the decrease in gal, and their values approached the corresponding values for the smooth-surface seal. Under the same rotor whirling velocity, the Ft for the partially helically grooved seals became lower than that for the smooth-surface seal (similar to the case for the through-helically grooved seal), although decreasing gal tended to increase Ft. These results suggest that partially helically grooved seals can improve the efficiency and stability margin of the pumps because of the reduction in leakage flow rate and suppression of the rotor forward whirling motion (with large radial and tangential dynamic reaction forces) as compared to conventional through-helically grooved seals. | |
